Heatrae Sadia 95.020.115 Handy No Touch Instantaneous Automatic 'No-Touch' Handwash Water Heater3.1kW 240V
Heatrae Sadia's Handy No Touch (Order Code: 95.020.115) is an instantaneous 3.1kW hand wash unit for a cost effective and hygienic means of providing hot water for hand washing. Simple operation with a no touch on/off control dial and tamper proof adjuster for temperature and flow control.
Order code: 95020115
Manufacturer: Heatrae Sadia
GTIN:
Notify me by email when product is available
We can notify you
when we have stock
when we have stock
Heatrae Sadia 95020115 Description
Heatrae Sadia's Handy No Touch instantaneous hand wash unit is a cost effective and hygienic means of providing hot water for hand washing.
- Easy to use No Touch on/off dial
- 'Power On' indicator
- Durable 200mm stainless steel swivel spout
- Consistent, splash free spray button
- Flow/temperature stabilised for constant outlet temperature
- Two levels of over temperature protection
- Excessive pressure protection
- 15mm female 'Push Fit' connection to water supplyNo touch control dial for on/off, temperature/flow setting via a tamper proof adjuster
- These units over comprehensive safety protection against the dangers of both scalding and excessive pressure build-up within the unit
- Two level cut-out. The first level cut-out operates at 520C and will re-set when the water has cooled down to 420C. The second level of protection operates in extreme conditions
- The flow/temperature stabiliser ensures that a consistent outlet temperature is maintained even in conditions of variable water pressure.
- The pressure relief device ensures that in the case of freezing or blockage, pressure is not allowed to build up to dangerous levels within the unit.
- Water running time of 25 seconds
- Extended spout (380mm) is available as an Accessory
- 2 year Guarantee
Heatrae Sadia 95020115 Features
Rating
3.1kW @ 240V (2.9kW @ 230V).
Controls
‘No touch’ control dial for on / off. Temperature and flow setting via tamper-proof adjuster.
Outer casing
White moulded ABS plastic cover.
Heat unit
Copper sheathed rod-type element.
Water container
Glass reinforced nylon.
Safety features
Self-resetting thermal cut-out set at 52°C for over heat protection.
Non self-resetting second stage cut-out set at 92°C.
Pressure relief device in the base of the container to prevent high-pressure build-up.
Flow / temperature stabiliser maintains consistent outlet temperature under variable water pressure conditions.
Pressure sensor cuts off power if flow is inadequate.
Ingress protection
IPX5
Approvals
Kiwa approved to UK water supply regulations. CE marked.
Fixing
Base assembly is secured to wall by two fixing screws, followed by electrical and plumbing connections. The spout and front cover are then attached. Two screws secure the front cover.
Plumbing
15mm female push fit at the base of the unit for bottom or rear (concealed) entry. Incoming feed pressure should be between 0.1Mpa (1 bar-14.5psi) and 0.7Mpa (7 bar-100psi).
Electrical
Cable entry from rear or bottom of unit.
Special requirements of the BS 7671 (IEE Wiring Regulations) should be observed when installed in bathrooms.
Units must be permanently connected to the electrical supply through a double-pole linked isolating switch.
Can be supplied from a ring final circuit via a fused spur with a double pole linked isolating switch with a 13A minimum breaking capacity.
Cable – 1.5–2.5mm².